Eibach nyomtávszélesítö Pro-Spacer 2x30mm S90-4-30-037-B KIA CEE'D, CEE'D Station wagon Van, CEE'D SW, CEE'D Hatchback, CEE'D Sportswagon, Ceed, Ceed Station wagon Van, Ceed Hatchback Van, Ceed Sportswagon, Ev6, Optima, Optima Sportswagon, Pro CEE'D, Pro

S6: Only for use on the rear axle!
S9: ATTENTION - ALSO NOTE ON SERIES WHEELS! - When using the wheelspacers you have to verify that the wheels being used have suitable cut-outs to take up the original bolts. Without these cut-outs it is not possible to use the wheels or wheelspacers! Please check as follows: Stud lengh (e.g. 25mm) minus spacer-thickness (e.g.15mm) = 10mm exess length. So the cut out should have 11mm depth to take the original stud. Further the cut out should have minimum 22mmx22mm height/width to take the overlaping nut. It´s allowed to shorten the stud bolt with a saw (Maximal up to the beginning of the nut. - We recommend only to shorten the minimum lengh.) If shorten the stud bolts, first please consider that all wheels used at the car still will fit (e.g. summer- / winterwheels) ATTENTION: when using 15 mm wheelspacers at least 7 mm deep cut-outs are needed (at 20mm wheelspacers at least 2mm deep cut-outs are needed) as the nuts stand over the contact surface! It´s allowed to shorten the stud bolts